Veneer Source - Your Complete Veneer reSource Veneer Source - About Us Veneer Source - Contact Veneer Source
Veneer Source - Products Veneer Source - About Veneer Veneer Source - Veneer Selections Veneer Source - AWI Specifications Veneer Source - Educational Information

Veneered panels used in casework or paneling in the same area may be matched to each other. This important component of the project must be carefully detailed and specified. The natural growth patterns of the tree will cause the figure on the sequential panels to ascend, descend, or show a “grain progression” as the eye moves from panel to panel. These illustrations were developed in Imperial measure and have not been converted for this edition. The four common methods are:

These are one step above stock plywood panels, usually made and warehoused in 4' x 8' or 4' x 10' sheets in sequenced sets. They may be produced from a single flitch or a part of a flitch, usually varying in number from 6 to 12 panels. If more than one set is required, matching between the sets cannot be expected. Similarly, doors or components often cannot be fabricated from the same flitch materials, resulting in noticeable mismatch. This is often the most economical type of special panel products.

2 - Pre-manufactured Sets - Selectively Reduced in Width

3 - Sequence-Matched Uniform Size Set

4 - Blueprint-Matched Panels and Components

Did you know ...

... that managed forests, thanks to their high proportion of young, strong, growing trees, enable CO2 to be extracted?

... that an old, unmanaged forest produces as much CO2 through processes of decomposition and decay as it stores, and that therefore an unmanaged forest contributes nothing to reducing global CO2?

Veneer Source • 400B Pittman St, Orlando, FL 32801
Phone: 407-423-2252 • Fax: 407-423-1566 •